Compliance Information Statement - Yamaha YDS-12 Owner's Manual

FCC INFORMATION (for US customers only)
Utilize power outlets that are on different
branch (circuit breaker or fuse) circuits or
install AC line filter/so
The above statements apply ONLY to those
products distributed by Yamaha Corporation of
America or its subsidiaries.
In the case of radio or TV interference,
relocate/reorient the antenna. If the antenna
lead-in is 300 ohm ribbon lead, change the
lead-in to coaxial type cable.
If these corrective measures do not produce
satisfactory results, please contact the local
retailer authorized to distribute this type of
product. If you can not locate the appropriate
retailer, please contact Yamaha Electronics Corp.,
USA 6660 Orangethorpe Ave., Buena Park, CA
90620.
This equipment generates/uses radio frequencies
and, if not installed and used according to the
instructions found in the users manual, may cause
interference harmful to the operation of other
electronic devices.
1. IMPORTANT NOTICE: DO NOT Compliance with FCC regulations does not
MODIFY THIS UNIT!
guarantee that interference will not occur in all
This product, when installed as indicated in the installations. If this product is found to be the
instructions contained in this manual, meets source of interference, which can be determined
FCC requirements. Modifications not expressly by turning the unit "OFF" and "ON", please try to
approved by Yamaha may void your authority, eliminate the problem by using one of the
granted by the FCC, to use the product. following measures:
2. IMPORTANT: When connecting this product
Relocate either this product or the device that is
to accessories and/or another product use only being affected by the interference.
high quality shielded cables. Cable/s supplied
with this product MUST be used. Follow all
installation instructions. Failure to follow
instructions could void your FCC authorization
to use this product in the USA.
3. NOTE: This product has been tested and
found to comply with the requirements listed in
FCC Regulations, Part 15 for Class "8" digital
devices. Compliance with these requirements
provides a reasonable level of assurance that
your use of this product in a residential
environment will not result in harmful
interference with other electronic devices.
COMPLIANCE INFORMATION STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:
1) This device may not cause harmful interface, and
2) This device must accept any interference received including interference that may cause undesired
operation of this device.
See user manual instructions if interference to radio reception is suspected.