Promaster D200R Owner's Manual

Multi-function Studio Flash
OWNER'S MANUAL
Safety Precautions:
1. Before using the flash, make sure that the electrical power supply matches the power requirements indicated on your lighting
equipment. Do not use any power other than the AC specification indicated on your equipment.
2. Do not expose your lighting equipment to sunshine, moisture, dust, dirt, rain, or water.
3. Any exposure to chemical solutions, gasoline, grease, oil, paint, or detergents can result in permanent damage to your
equipment.
4. Do not insert metal parts into any lighting equipment.
5. Dry your hands before handling the equipment. Touching your equipment with wet hands is dangerous to both the equipment and
to you.
6. To unplug your equipment, grasp only the plug. Do not unplug by pulling the electrical wire.
7. If your flash beeps continuously or does not function, turn your flash off and unplug for 30 seconds to reset.
8. Do not attempt to repair your lighting equipment. If a problem arises, contact the store from which you purchased the light.

Specifications:

Model
Power source
Strobe output
Guide No. (ISO100)
Cooling fan
Power Range
Recycle time
Flash duration
Beam angle
Slave sensitivity
Modeling lamp
Color temperature
Synch cord voltage
Triggering
Fuse
Housing size(mm)
Weight
Light Body &Rear Control Panel
8
7
D200R – Code 7893
AC100－130V / 60Hz
200WS
45m
Built-in mini fan cooler
1/32~1/1(5 steps) Continuously
1/800－1/10000s
Synch cord/Test flash switch/Slave sensor/Integrated RF trigger
136×127×320mm
2.2kg
9
17
18
13
14
-1-
D400R – Code 7900
400WS
0.5－1s
55 °
10 m
150W / E27
5600K
6V DC
10A
2.5kg
6
5
Buzz
4
Model
Free/Prop
3
SYNC
POWER
2
1
16
15
65m
9
Ready
Test
10
ON Cell
RF
11
OFF
MODE
12
13
14