Promaster LED120 Manual

Light panel

LED Light Panel

LED120

Thank you for purchasing the PROMASTER

LED120 Light Panel.

Please read the following instructions to ensure the best

operation of your light panel.

Installing the Batteries

Remove the battery cover from the back of the light by gently squeezing the two battery door locking tabs.

Insert 4 AA batteries (not included) as shown. Be sure the batteries are inserted with the correct polarity (+,-) as shown in the battery

compartment.

After the batteries are properly installed use the power switch to turn your light panel on or off.

Your LED120 light is supplied with a 3300K correction filter that helps give you the best color balance when shooting under ambient

tungsten lighting. This filter is easily installed by snapping over the edge of your LED120 light. To remove, simply lift the filter off.

3300K Filter

LED120 with

filter installed

Table of Contents

Do you have a question about the LED120 and is the answer not in the manual?

Page 1: Installing The Batteries
Your LED120 light is supplied with a 3300K correction filter that helps give you the best color balance when shooting under ambient tungsten lighting. This filter is easily installed by snapping over the edge of your LED120 light. To remove, simply lift the filter off.
Page 2: Specifications
Beam angle: 60° Luminance: 51 Lux @ 10’ Color rendering index: ≥85 Color temperature: 5600K LED longevity: >10000h Power input: AA Battery × 4 Housing size(mm): 94 x 93 x 38 Weight(g): Code 7200 Made in China www.promaster.com Fairfield, CT 06611...