Honda Element 2003 Owner's Manual page 143

Main Menu
Table of Contents
TUNE Use the TUNE knob to
tune the radio to a desired frequency.
Turn the TUNE knob to the right to
tune to a higher frequency, or to the
left to tune to a lower frequency.
Stop turning the knob when the dis-
play reaches the desired frequency.
SEEK The SEEK function
searches the band for a station with
a strong signal. To activate it, press
either SEEK button (
then release it. Depending on which
SEEK button you press, the system
scans upward or downward from the
current frequency. It stops when it
finds a station with a strong signal.
SCAN The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. When the system is
in the SCAN mode, SCN shows in
the display. The system will scan up
the band for a station with a strong
signal. When it finds one, it will stop
and play that station for about five
seconds. If you do nothing, the
system will then scan for the next
strong station and play that for five
seconds. When it plays a station that
you want to continue listening to,
press the SCAN button again.
Preset You can store the
frequencies of your favorite radio
or ), stations in the six preset buttons.
Each button will store one frequency
on the AM band, and two
frequencies on the FM band.
To store a frequency:
1. Select the desired band, AM or
FM. FM1 and FM2 let you store
two frequencies with each preset
button.
Audio System
Use the TUNE, SEEK, or SCAN
2.
function to tune the radio to a
desired station.
Pick the preset button you want
3.
for that station. Press the button
and hold it until you hear a beep.
4. Repeat steps 1 to 3 to store a total
of six stations on AM and twelve
on FM.
Once a station's frequency is stored,
simply press and release the proper
preset button to tune to it.
The preset frequencies will be lost if
your vehicle's battery goes dead, is
disconnected, or the radio fuse is
removed.
Comfort and Convenience Features
CONTINUED
139