Longer Pre-Wash For Cottons; Suds Cooling; Code - Miele SUPERTRONIC Operating Instructions Manual

Longer pre-wash for Cottons

The pre-wash for the Cottons
programme can be extended by 6, 9
or 12 minutes.
The default setting for the pre-wash is
25 minutes.
If you require a longer pre-wash, this
can be extended.
An additional pre-wash time is not
selected in the default settings.

Suds cooling

When this is activated, additional
water flows into the drum at the end
of the main wash to cool the suds
down. Hot suds can damage plastic
drainage pipes.
Suds cooling takes place when a
Cottons programme with a temperature
of 70°C or higher is selected.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipes do not
comply with DIN 1986.
The machine is delivered with Suds
cooling set to Off.
Settings menu

Code

The code prevents your machine
being used without your knowledge.
When the code has been activated, you
have to enter a code after switching the
washing machine on. Otherwise the
washing machine cannot be operated.
To activate the code
You are asked to enter a code. The
code is 125 and cannot be altered.
^ Press
+
to enter the first number.
^ Confirm with
OK
next number. Repeat the process
until all three numbers have been
entered.
^ After the last number has been
entered, you must confirm the code
OK
with .
To use the washing machine when
the code is activated
When the machine is switched on
again, the display will request the lock
code.
^ Enter the code 125 by pressing the
-
and sensors.
^ The washing machine is now
unlocked and ready for use.
To deactivate the code
^ Proceed as before with activating the
code.
You can now use the washing machine
without being asked to enter the code.
before moving to the
!
+
83