FIRE, ELECTRICAL SHOCK, OR INJURY TO ÉLECTRIQUE, OU LA BLESSURE AUX PERSONS CHALICE SERIES PERSONNES POUR CHALICE. LIGHTING FIXTURES. WARNING! - TO REDUCE THE RISK OF FIRE, AVERTISSEMENT! - POUR RÉDUIRE LE RISQUE ELECTRIC SHOCK, OR INJURY TO PERSONS, D'INCENDIE, LE CHOC ÉLECTRIQUE, OU LA...
LED Down Light Fixture DESCRIPTION he CHALICE LED lighting fixture is a surface mount unit with a canopy. The overall construction of the fixture includes corrosion protected steel housing and aluminum cooling system. The fixture is supplied with a state of the art microprocessor-controlled solid-state LED light engine incorporating 3-watt Luxeon Rebel Red, Green, Blue, and Amber color LEDs or White Rebel LEDs, and an on-board power supply.
SETUP AND INSTALLATION Unpacking Remove the CHALICE lighting fixture from its shipping box. Set the unit down on a flat surface before proceeding. Remove the top six screws, lift the light engine assembly straight out and remove protective shipping paper between the front lens and LEDs. If needed, remove stock lens and install any other accessories like a snoot, louver, spread lens etc.
Page 5
M A N U A L FEATURES The CHALICE LED lighting fixture is the first of its kind in the Theatrical and Architectural Lighting Industry and adds to the Spectra-LED family of solid state LED luminaires offered by Altman Lighting.
I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L OPERATION ( Firmware Version: V2.3.2) SETTINGS There are 3 buttons below the 3 digit LED display on the side of the unit. The buttons are : (From left to right) [ HUNDREDS ] , [ TENS ] , [ ONES ].
Page 7
( below the ), and that enters personality #05 into memory. PERSONALITY ADDRESS SETTINGS LIST ( 601-608 ) 4-COLOR CHANNELS: (For White color LED Chalice with DMX, replace RGBA with W1W2W3W4 below) ------------------------------------------------------------------------------------------------------- 601 = Personality #01 8 Bit ,...
Page 8
I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L RESOLUTION is selectable as either: 8 Bit (one DMX channel per color) this is normal resolution, 16 Bit (two DMX channels per color Coarse+Fine high resolution similar to moving lights).
Page 9
I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L STAND-ALONE EFFECTS (does not require a control console): Note: stand-alone effects from a single unit will control other units connected via DMX cable to all synchronize.
I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L Locked Mode To Lock (or unlock) the buttons: >Wait a few seconds until the display goes blank, >...
Page 11
I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L...
Page 12
I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L LENS MOUNTING PROCEDURE: Insert first into two springs at an angle of 30 degrees.
Page 13
I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L Make sure that the lens is completely secured in all four springs. Make sure that the lens is completely snapped into all the four springs provided as shown in the...
Page 14
Insert stem with canopy all the way in. Hold the top three wires at the top end and fasten stem into top lid of chalice by rotating clock wise until the stem stops rotating.
Page 15
I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L This manual is also available online at: www.altmanlighting.com.
Need help?
Do you have a question about the CHALICE and is the answer not in the manual?
Questions and answers