Sony HT-SF2300 Operating Instructions Manual page 69

Outdoor FM antenna
Tuner
•
Ground wire
(not supplied)
+
To ground
FM
750
COAXIAL
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas are connected
securely. Adjust the antennas and connect
an external antenna, if necessary.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning (page 50).
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning
by scanning preset stations). Preset the
stations (page 50).
RDS does not work.
a )
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The control for HDMI function does not
work.
• Check the HOMI connection (page 20).
• Make sure "CONTROL FOR HOMI" is
set to "CTRL ON" in VIDEO menu.
• Make sure the connected component is
compatible with the Control for HOMI
function.
• Check the Control for HOMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• Repeat the procedures of "Preparing
Control for HOMI function" if you change
the HOMI connection, connect/disconnect
the AC power cord, or there is a power
failure (page 56).
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the "AUDIO FOR
HOMI" settings in VIDEO menu to
- "TV+AMP" if you want to listen to the
sound from the TV speaker and
receiver.
- "AMP" if you want to listen to the
sound from the receiver.
• If you cannot listen to the sound of a
component connected to the receiver
- Select the appropriate input when you
want to watch a program on a
component connected via HDMI
connection to the receiver.
- Change the TV channel when you want
to watch a TV broadcast.
- Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
conunued----------
69
GB