Download Print this page

Oransi OVHPRO201 User Manual page 3

V-hepa pro air purifier the complete air purifier

Advertisement

Control Panel and LCD Display:
HEPA Change
or Clean
ION
Speed Setting
Timer Setting
1.Before operating the air purifier, make sure the air filters
inside the air purifier are not wrapped in plastic. When the
air purifier is plugged in you should hear a beep. Press the
Power button to turn it on. If the air purifier does not power
on, ensure the front cover is installed correctly. See the How
to Use section for more information.
2.The v-hepa Pro air purifier has 3 fan speeds and auto mode.
The fan speeds are represented by Roman numerals (I, II, III).
By pressing the mode button you will cycle through the fan
speeds and auto mode as follows: I
UV
Reset
ION/UV
ON/OFF
Switch
Switch
II
III
Auto.
3. Press the Timer button to initiate the count down timer.
Pressing the timer button will cycle through the countdown timer
settings (in hours). The settings are 1 hour, 2 hours, 4 hours, 6
hours, 8 hours, off.
4. When the air purifier is turned on, the UV lamp and negative
ionizer will be on and the LCD display will show movement in
the UV and ion sections. Press the Ion/UV button to turn this f
eature off. If the Ion/UV display is showing with no movement
on the LCD, it is an indication that the UV lamp requires
replacement or adjustment.
5. When the air purifier is in the Auto mode, the fan speed of the
air purifier will be automatically controlled depending upon the
reading of the API. The API shows the air quality in your room
based upon a reading from the dust sensor that is located on the
left side of the air purifier. The API will display more bars to
indicate higher particle levels. Higher readings in the API will
result in the air purifier operating at a higher fan speed.
6. Reset operation. The v-hepa Pro has a filter replacement
indicator to remind you when it is time to check and/or replace
the HEPA filter. When you see
HEPA label on the LCD display it is time to check the filter. To
reset the filter replacement indicator, press the Reset button
with a paperclip or safety pin.
displayed beneath the

Advertisement

loading