Page 1
Service Questions: Contact Oransi at 888-281-3948 Sales Inquiries: Contact Sylvane at (800) 934-9194 or visit sylvane.com OWNER’S MANUAL Finn Air Purifier Model No.: OVHT9908...
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. WARNING: RISK OF ELECTRICAL SHOCK Safety precautions should always be used when operating this or any electrical appliance. Decrease the risk of electrocution, electric shock, injury or fire by reading and following all of the warnings below. ...
Note: Before operating the air purifier, make sure the air filters inside the air purifier are not wrapped in plastic. When the air purifier is plugged in you should hear a beep. Press the Power button to turn it on. If the air purifier does not power on, ensure the front cover is installed correctly.
OPERATION PRE-OPERATING INSTRUCTIONS 1. Carefully remove your air purifier from the gift box and the bag. 2. Remove the back cover and remove the filter from the bag. 3. Select a firm level and flat location. For proper air flow, locate the unit at least 1 foot (0.3 M) from any wall or furniture.
Page 6
4. Pressing Fan Speed Button ( ) at this point will set the air purifier into Medium fan speed ( 5. Pressing Fan Speed Button ( ) again will set the air purifier into Low fan speed ( 6. Pressing Fan Speed Button ( ) once more will set the air purifier back to High fan speed ( 7.
CLEANING AND MAINTENANCE CLEANING PRE-FILTER (See Air Cleaning System) 1. Turn off and unplug the unit; 2. Press the Lock & Release Button and remove the Rear Cover from the unit; NOTE: The unit will shut off after the rear cover is removed. - 5 -...
3. Remove the pre-filter from the rear cover. Clean the pre-filter with the vacuum brush attachment of your vacuum cleaner. This will remove lint and dirt from the filter. Use a clean, damp, soft cloth to wipe the pre-filter again. NOTE: Clean the pre-filter often if possible.
Page 9
3. Remove the HEPA filter. 4. Use the brush attachment with your vacuum cleaner to clean the filter. CAUTION: Do not use water or any household cleaner to clean the HEPA filer. NOTE: The HEPA filter can be used continuously for up to two years. When the HEPA filter turns from white to black, it should be replaced with a new one.
5. Depending upon your filter type, either it will only fit in one way or reference the arrow on the side of the filter. Install the rear cover back to unit and securely latch in place. NOTE: Both of filter and rear cover must be installed otherwise the purifier will not power on.
Page 11
3. Remove the HEPA filter. 4. Use a screwdriver to remove the two screws and detach the UV lamp cover. - 9 -...
Page 12
You should minimize the contact time with your fingers on the glass. CAUTION: UV lamp is a glass product, please handle it carefully. Please reference www.oransi.com for more information including a video demonstration that shows how to replace the UV lamp.
CLEANING AND MAINTENANCE 1. The air purifier should be checked at least once every month. More frequent cleaning may be required depending upon environmental conditions. 2. Clean the HEPA filter and pre-filter with the vacuum brush attachment of your vacuum cleaner. This will remove lint and dirt. See CLEANING PRE-FILTER and CLEANING HEPA FILTER on page 5 to 6.
Page 14
Service Questions: Contact Oransi at 888-281-3948 Sales Inquiries: Contact Sylvane at (800) 934-9194 or visit sylvane.com...
Need help?
Do you have a question about the OVHT9908 and is the answer not in the manual?
Questions and answers