Subaru Legacy 2003 Service Manual page 29

16) Remove the plug from rear side of camshaft.
NOTE:
• Do not remove the oil seal unless necessary.
• Do not scratch the journal surface when remov-
ing oil seal.
B: INSTALLATION
1) Apply a coat of engine oil to the camshaft jour-
nals, and then install the camshaft.
2) Install the camshaft cap.
(1) Apply liquid gasket on the around of cam-
shaft cap.
Liquid gasket:
THREE BOND 1280B
P/N K0877YA018
NOTE:
Apply a coat of 3 mm (0.12 in) dia (A). liquid gasket
along edge (B) of the camshaft cap (C) mating sur-
face.
( A )
( B )
(2) Temporarily tighten the bolts (g) through (j)
in alphabetical sequence.
( i )
( j )
CAMSHAFT
ME-00264
( C )
ME-00265
( g )
( h )
ME-00266
ME(H4SO)-57
(3) Install the valve rocker assembly.
(4) Tighten the bolts (a) through (h) in alphabet-
ical sequence.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
( a )
( g )
( f )
( d )
(5) Tighten the TORX bolts (i) through (n) in al-
phabetical sequence using ST.
ST 499497000 TORX PLUS
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
( k )
( n )
MECHANICAL
ME-00267
( c )
( e )
( h )
( b )
ME-00268
( i ) ( m )
( l )
( j )
ME-00269