Subaru Legacy 2003 Service Manual page 20

MECHANICAL
(3) With a 2 mm (0.08 in) dia. stopper pin or a 2
mm (0.08 in) (nominal) dia. hex bar wrench in-
serted into the stopper pin hole in the cylinder,
secure the adjuster rod.
2) Install the automatic belt tension adjuster as-
sembly.
Tightening torque:
39 N·m (4.0 kgf-m, 28.9 ft-lb)
3) Install the belt idler (No. 1).
Tightening torque:
39 N·m (4.0 kgf-m, 28.9 ft-lb)
TIMING BELT ASSEMBLY
2. TIMING BELT
1) Preparation for the installation of automatic belt
tension adjuster assembly. <Ref. to ME(H4SO)-47,
AUTOMATIC BELT TENSION ADJUSTER AS-
SEMBLY AND BELT IDLER, INSTALLATION,
Timing Belt Assembly.>
2) Installation of timing belt
ST1 18231AA010 CAMSHAFT SPROCKET
NOTE:
ME-00437
Also the CAMSHAFT SPROCKET WRENCH
(499207100) can be used.
ST2 499207400
ME-00241
3) Install the belt idler No. 2.
ME-00242
Tightening torque:
ME(H4SO)-48
(1) Turn the camshaft sprocket No. 2 using
ST1, and then turn the camshaft sprocket No. 1
using ST2 so that their alignment marks (A)
come to top positions.
WRENCH
CAMSHAFT SPROCKET
WRENCH
( A )
(2) While aligning alignment marks (B) on the
timing belt with marks (A) on sprockets, position
the timing belt properly.
( B )
( A )
39 N·m (4.0 kgf-m, 28.9 ft-lb)
ME-00243
( A )
ME-00244