Subaru Legacy 2003 Service Manual page 10

MECHANICAL
11) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
12) Tighten the nuts which install front cushion rub-
ber onto crossmember.
Tightening torque:
85 N·m (8.7 kgf-m, 63 ft-lb)
NOTE:
Make sure the front cushion rubber mounting bolts
(A) and locator (B) are securely installed.
( B ) ( A )
13) Install the front and center exhaust pipe. <Ref.
to EX(H4SO)-6, INSTALLATION, Front Exhaust
Pipe.>
14) Connect the following hoses.
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
15) Connect the following connectors.
(1) Engine ground cables
Tightening torque:
14 N·m (1.4 kgf-m, 10.1 ft-lb)
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connectors
(5) Power steering pressure switch
16) Connect the following cables.
(1) Accelerator cable
(2) Cruise control cables (With cruise control)
17) Adjust each connected cable.
ENGINE ASSEMBLY
ME-00219
( A ) ( B )
ME-00220
ME(H4SO)-38
18) Install the air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
19) Install the A/C pressure hoses. <Ref. to AC-42,
INSTALLATION, Flexible Hose.>
20) Install the radiator to vehicle. <Ref. to
CO(H4SO)-24, INSTALLATION, Radiator.>
21) Install the air intake duct and air cleaner case.
<Ref. to IN(H4SO)-7, REMOVAL, Air Intake Duct.>
and <Ref. to IN(H4SO)-6, INSTALLATION, Air
Cleaner Case.>
22) Install the under cover.
23) Install battery in the vehicle, and then connect
the cables.
24) Fill engine coolant. <Ref. to CO(H4SO)-14,
FILLING OF ENGINE COOLANT, REPLACE-
MENT, Engine Coolant.>
25) Check the ATF level and correct if necessary.
(AT vehicles) <Ref. to AT-30, INSPECTION, Auto-
matic Transmission Fluid.>
26) Charge the A/C system with refrigerant. <Ref.
to AC-24, OPERATION, Refrigerant Charging Pro-
cedure.>
27) Remove the front hood stay, and then close the
front hood.
28) Take off the vehicle from lift arms.
C: INSPECTION
1) Make sure the pipes and hoses are installed cor-
rectly.
2) Make sure the engine coolant and ATF are at
specified levels.