Removing The Door Cover; Removing And Installing The Door Panels - Bosch HBA63B2.0A Instruction Manual

Built-in oven
Table of Contents

Advertisement

Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
$
Fold back both locking levers (figure C). Close the oven
3.
door.
&
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after­sales service.

Removing the door cover

The oven door cover can become discoloured. To carry out
thorough cleaning, you can remove the cover.
Open the oven door fully.
1.
Unscrew the oven door cover. To do this, undo the left and
2.
right screws (figure A).
Remove the cover (figure B).
3.
$
Make sure that the oven door is not closed while the cover is
removed. The inner panel may be damaged.
Clean the cover with a stainless-steel cleaning agent.
Replace the cover and secure it in position.
4.
Close the oven door.
5.
%
%

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the sequence
in which the panels are removed. In order to reassemble the
panels in the correct sequence, use the numbers that appear
on each panel.
Removal
Detach the oven door and lay it on a cloth with the handle
1.
facing down.
Unscrew the cover at the top of the oven door. To do this,
2.
unscrew the left and right screws (fig. A).
Lift the top panel up and pull it out and remove the two small
3.
seals (fig. B).
$
Unscrew the retaining clips on the right and left. Lift the panel
4.
and remove the clips from the panel (fig. C).
Remove the seal from the bottom of the panel (fig. D). Pull
5.
the seal and remove it up and out. Pull out the panel.
&
Pull the lower panel at an angle, upwards and out.
6.
Do NOT unscrew the left and right-hand screws from the
7.
sheet metal part (fig. E).
(
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
%
'
15

Advertisement

Table of Contents
loading

Table of Contents