Hints For Timer Recording; The Priority Of Overlapped Settings; Note For Dvd Recording - Toshiba DR430KU Owner's Manual

::J ....
..,
o
0-
;C'
,..
,
...
0'
..
• To cancel the timer standby mode, press
[I/O ON/STANDBY].
• When the starting and the ending time are the same,
"Exceeds 12 hours" appears and the program setting will
not be accepted.
• When the programmed starting and ending time are
earlier than the current time, the setting will not be
accepted.
• If the starting time is earlier and the ending time is later
than the current time, the recording will start right after
[I/O ON/STANDBY]
is pressed.
• "Press ON/STANDBY for timer recording" will appear on
the TV screen 5 minutes before the programmed
starting time.
TIMER RECORDING
PROG.A
The first 2 minutes (at the longest) will be cut off.
• If there is a power failure or this unit has been
unplugged for more than 30 seconds, the clock setting
and all timer programming will be lost.
• If a disc is not inserted or if a inserted disc is not
recordable (finalized DVD-RW/-R, finalized DVD+RW, a
fully recorded disc, etc.), @] on the front panel display
flashes and timer recording cannot be performed. In
some cases, @] will appear momentarily around the start
point as the unit attempts to record. Please insert a
recordable disc.
• When all the timer recording is completed, @]f1ashes. To
play back or eject the recorded disc, press
[I/O ON/STANDBY] first, then select the recorded title and
press [PLAY
~],
or [OPEN/CLOSE .A.] to remove the disc.
• During timer recording or timer standby mode (@] will
appear), any operations on the unit will not be available.
To make these operations available, press [STOP.] or
[. STOP]
to stop the timer recording or
[I/O ON/STANDBY]
to cancel timer standby mode (@]
will disappear).
The Priority of Overlapped Settings
This unit records the programs according to priority if the timer programmings are overlapped. The timer
programming set previously has priority.
A timer recording of lower priority will be canceled or start from the middle.
Check the overlapped timer programmings and change the priority if necessary.
• When the starting time is the same: • When the starting time and the ending time
A program set previously (PROG. A) has priority. for each programs are different:
A program that has earlier start time has priority.
L _ _-
Ii.
.PROG.S"
• When the
endtimeofthe:~l'pg;a:R'!~ing
" _
cu..
rently~lng rec~"dltd a~.d
the start time
of
the subsequent program aresame:;!' ,
.The beginning Qfthe PROG.-B mayoe
q.lt
Off..
• When the recording time is entirely overlapped:
PROG.A will not be recorded.
,Note for DVD recording
• When the recording time of 2 programs are overlapped, or
, the end time of a program and the start time of another
program is the same, the first 2 minutes (at the longest) of
the subsequent program will be cut off.
• If the cut-off portion comes up to 3 minutes or more, this
<program will be displayed with errors number E40 in the
;'tilTler 'programming list.
• When the recording time is partially overlapped:
PROG. A will start after PROG. Bis complete to
be recorded.
EN 41