Renkus-Heinz PF1-500 Instruction Manual page 3

CF/CFX101LA
Step 4.
Remove the Balance Control plate from the
cabinet.
Step 5.
Disconnect the white 4-pin connector from
the Balance Control (Crossover Network)
by squeezing the sides of the connector and
pulling.
Step 6.
If you are installing a PF2-500R bi-amplifier,
connect the white 4-pin connector to the
amplifier.
Note that this bypasses the Balance Control
(Crossover Network) and it no longer will have
any effect on the loudspeaker's performance.
Step 7.
If you are installing a PF1-500 or PF1-500R
amplifier, connect the white 2-pin connector to
the amplifier.
Note that this keeps the Balance Control
(Crossover Network) in the audio path.
Step 8.
Carefully slide the amplifier into the cabinet
and use the Phillips head screws to secure it
in place.
Step 9.
If you are installing a PF2-500R bi-amp-lifier
into a CFX101LA, reinstall the Balance Con-
trol plate and secure it into place.
Page 3