Host Parameters - Symbol LS1203 Product Reference Manual

6 - 4 LS1203 Product Reference Guide
RS-232 Host Parameters
Various RS-232 hosts are set up with their own parameter default settings
Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed below.
Terminal Specific RS-232
Table 6-2
Standard
Parameter
(Default)
Transmit Code No
ID
Data Data as is
Transmission
Format
CR/LF
Suffix
(7013)
Baud Rate 9600
Parity None
Hardware None
Handshaking
Software None
Handshaking
Serial Response 2 Sec.
Time-out
Stop Bit Select One
ASCII Format 8-Bit
Beep On <BEL> Disable
Low
RTS Line State
Prefix None
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.
**If Nixdorf Mode B is scanned without the scanner connected to the proper host, it may appear unable to scan. If this
happens, scan a different RS-232 host type within 5 seconds of cycling power to the scanner.
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS terminal enables the
transmission of code ID characters listed in
and are separate from the Transmit Code ID feature. The Transmit Code ID feature should not be enabled for
these terminals.
ICL Fujitsu
Yes Yes
Data/Suffi Data/Suffix
x
CR (1013) CR (1013)
9600 9600
Even None
RTS/CTS None
Option 3
None None
9.9 Sec. 2 Sec.
One One
8-Bit 8-Bit
Disable Disable
High Low
None None
Table 6-3
(Table
Wincor-Nix
Wincor-Ni
dorf
xdorf
Mode
Mode A
B/OPOS
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
Odd Odd
RTS/CTS RTS/CTS
Option 3 Option 3
None None
9.9 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low = No
data to send
None None
below. These code ID characters are not programmable
6-2). Selecting the ICL, Fujitsu,
Olivetti Omron
Yes Yes
Prefix/Data/Suffi Data/Suffi
x x
ETX (1002) CR
(1013)
9600 9600
Even None
None None
Ack/Nak None
9.9 Sec. 9.9 Sec.
One One
7-Bit 8-Bit
Disable Disable
Low High
STX (1003) None