Waterwise 9000 Use & Care Manual page 7

Figure D
Boiler Cap
Boiler Cap
Gasket
10. Slide boiler into chassis compartment and press fi rmly to ensure boiler
is properly placed (fi g. E). To prevent personal injury or property
damage, the boiler must be fully engaged prior to start-up.
11. Plug power cord into a properly rated, grounded outlet.
12. Press "Start" button at base of boiler (fi g. E). "Start" button will illum-
inate when heating; however, the light will go out and boiler will stop
heating if electrical power is interrupted or stopped. If this occurs,
press "Start" button again to restart the distillation cycle.
NOTE: The cooling fan will not start immediately because of a
delayed fan start-up feature. The fan will start once the boiler has
reached a predetermined temperature, approximately 30 to 40 minutes
after starting the cycle.
WARNING: To prevent personal injury, burn and/or scald injury,
DO NOT remove boiler while "Start" button is illuminated or at any time
when the boiler is hot. Always unplug Distiller from wall outlet and allow
boiler to cool completely before removing it from the Distiller (at least 30
Figure E
Distiller
Chassis
Start
Button
Waterwise 9000 Distiller Use & Care Guide
Boiler
Boiler
Steam Baffl e Securing Nut
Spout
Maximum Fill Point
(bottom of tabs)
minutes). DO NOT change
position or location of Dis-
tiller while it is operating or
cooling.
13.
14.
Steam Baffl e (fl at side)
O-ring
Flange
Gasket
Place prepared carbon
fi lter cup into opening
at the top of the collec-
tor/dispenser bottle.
DO NOT install cap
onto bottle (fi g. F).
Replace the collector/
dispenser bottle
(fi g. F). Make sure the
dispensing valve is
securely tightened.
7