110/220 Volt Convertible Models; Electrical Installation Instructions 110 Volt Models; Electrical Spa Wiring Connection Instructions 110 Volt Models - Saratoga Spa LUXURY SERIES Owner's Manual

110 / 220
- Polo
- Adelphi
110 Volt Electrical Requir ements:
The above models are manufactured with the SC-MP 110V/220V convertible spa pack.The
units are factory wired for 220 Volt applications with 4 kW heater operation.The models
can be converted for 110 Volt applications and to run with a 1 kW heater operation.
The 110 Volt models must be connected to a "dedicated" 110 Volt 20Amp grounded circuit.
The term "dedicated" means the electrical circuit is not being used for any other electrical
items (lights, appliances, etc.). If the spa is connected to a non-dedicated circuit, overloading
will occur and nuisance tripping of the GFCI breaker switch at the house breaker panel or
GFCI cord will occur. Never connect the spa to an extension cord.
The 110 Volt models may be optionally equipped with a GFCI power cord (approximately 13
feet long).These models must be plugged into a grounding type, 110 Volt 20 Amp receptacle
as shown below. No other electrical appliances or fixtures should be used on this circuit.
DEDICATED 110V, 20A RECEPTACLE
Data label amperage rating
of 16 Amps must use this
type of
20 Amp
dedicated
receptacle
and plug.
WARNING:
The use of any other receptacle or the connection of the plug to a 220 Volt service may cause the spa
pack to operate improperly, create the potential for an electrical hazard and may void the spas warranty.
Saratoga Spa models must be wired in accordance with all local electrical codes.All electrical
work should be done by an experienced, licensed electrician familiar with spa installations.
Note: As of January 1, 1996 the National Electrical Code (NEC) requires a GFCI (Ground
Fault Circuit Interrupter) on all spa installations.
Installation Instructions:
The following instructions are for the conversion of the SC-MP 110V/220V control pack
from a 220 Volt application to a 110 Volt application.
Important:
Use only approved pressure-type wire splicing lugs or connectors suitable for
the size and type of wiring used.
22
Volt Convertible Models
- Putnam
DEDICATED 110V, 15A RECEPTACLE
DO NOT USE
THIS TYPE