Briggs & Stratton Pressure Washer Operator's Manual page 13

3,400 psi
Hide thumbs Also See for Pressure Washer:
Table of Contents

Advertisement

Available languages

Available languages

9. Move throttle control lever (A) to "Fast" position,
shown on engine as a rabbit
10. Move choke lever (B) to "Choke"
B
NOTICE For a warm engine, be sure the choke lever is in
the "Run"
position.
NOTICE Before starting the pressure washer, be sure you
are wearing safety goggles as described below.
WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVER substitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
11. When starting engine, position yourself as
recommended below, grasp starter grip handle and pull
slowly until you feel some resistance. Then pull rapidly
to start engine.
.
A
position.
NOTICE Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
WARNING Starter cord kickback (rapid retraction) will
pull hand and arm toward engine faster than you
can let go which could cause broken bones,
fractures, bruises, or sprains resulting in serious
injury.
• NEVER pull starter cord without first relieving spray gun
pressure.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
12. Return starter grip handle slowly. DO NOT let rope
"snap back" against starter.
13. When engine starts, slowly move choke lever to "Run"
position, as engine warms. If engine falters, move choke
lever to "Choke"
position, then to "Run"
14. After each starting attempt, where engine fails to run,
always point gun in safe direction, press red button and
squeeze spray gun trigger to release high pressure.
15. If engine fails to start after six pulls, move choke lever
to "Run"
position, and repeat steps 11 through 13.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
• DO NOT allow CHILDREN to operate pressure washer.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• NEVER aim spray gun at people, animals, or plants.
• DO NOT secure spray gun in open position.
• DO NOT leave spray gun unattended while machine is running.
• NEVER use a spray gun which does not have a trigger lock or
trigger guard in place and in working order.
• Always be certain spray gun, nozzles and accessories are
correctly attached.
position.
13

Advertisement

Chapters

Table of Contents
loading

Table of Contents