MAC address 1 to 4
Wireless Module
Click "Apply" to save the changes, or click "Cancel" to discard the changes. After you
have clicked "Apply", you will see the following message:
Click "Apply" to save the changes and restart the broadband router. It takes about 60
seconds for the broadband router to restart. Click "Continue" to configure other settings.
connected wireless clients. Click "Refresh" in the
new window to renew the list, and click "Close" to
close the window.
Note: If you have a pop‐up blocker installed, you
may have to disable it, or set it to allow the pop‐up
window to show up.
Input the MAC addresses of the wireless access points
with which you wish to connect.
Select "Enable" to turn on the 5GHz wireless signal
and select "Disable" to turn it off.
96