Dhcp Server - Ovislink Air Live WIAS-3200N v2 User Manual

If the system enable authentication function and user in the privilege list, the user
*Note:
of bandwidth will be uncontrolled by Individual Bandwidth
Guest Service: By default, it's "Disable". To Enable to activate bandwidth control
service for guest users.
Guest Upload : The Guest Upload is in the range of 0~102400 Kbit/s, 0 indicates
unlimited, default is 512 Kbit/s
Guest Download : The Guest Download is in the range of 0~102400 Kbit/s, 0
indicates unlimited, default is 512 Kbit/s
Session Limit per IP: The number of sessions is in the range of 10~500, 0 indicates
unlimited, default is 0.
STP: By default, it's "Disable". To "Enable" to activate STP. the spanning tree network
protocol provides a loop free topology for any bridged LAN/VLAN. The Spanning Tree
Protocol, which is also referred to as STP, is defined in the IEEE Standard 802.1d.
3.4.6

DHCP Server

Service: Check "Enable" to activate DHCP Server on VLAN/LAN port.
Start IP / End IP: Specify the range of IP addresses to be used by the DHCP server
when assigning IP address to clients.
DNS1 / DNS2 IP: The Domain Name System (DNS) is an Internet "phone book" which
translates domain names to IP addresses. These fields identify the server IP
addresses where the DNS requests are forwarded by the WIAS-3200N v2.DNS1
server IP is mandatory. It is used by the DNS Proxy and for the device management
purpose. DNS2 server IP address is optional. It is used as the fail-over in case the
primary DNS server will become unresponsive.
WINS IP: Enter IP address of the Windows Internet Name Service (WINS) server; this
is optional.
Domain: Enter the domain name for this network.
23
AirLive WIAS-3200N v2 User's Manual
3 Configure Hotspot to Network