NOBOCOOL NC-49DP User Manual page 8

ASSEMBLY OF EXHAUST HOSE, HOSE INLET, HOSE OUTLET, WINDOW ADAPTOR
AND WINDOW SLIDER (Fig.4)
• Fully extend each end of the exhaust hose by about 10cm and attach the hose inlet and hose outlet to opposite ends by
rotating the inlet/outlet in a counter clockwise direction approximately 3 to 4 turns, making sure that the hose wire is
well threaded into the hose inlet and outlet. The hose inlet and outlet cannot be installed unless the hose ends have been
fully extended.
• Attach the window adaptor to the hose outlet by pressure fi t.
• Clip the window adaptor into the window slider. Take care to not break the tabs on the window adaptor when
disconnecting from the window slider.
window
slider
MOUNTING OF ASSEMBLED AIR EXHAUST HOSE (Fig.5)
• Take care not to damage the hose inlet when attaching/detatching at the back
of the Air Conditioner.
• Slide the hose inlet (square end) in the direction indicated by the arrow onto
the fi xing lugs on hot air outlet grill at the back of the appliance. Install
carefully and do not force.
• Place the hose outlet to the nearest window. The length of the air exhaust
hose is between 600mm to 1500mm; use the minimum length when working.
• When mounting, try to keep the air exhaust hose horizontal and do not extend
its length by attaching it to another hose as this reduces the cooling effi ciency
of the appliance. If hose needs to be extended, use as few bends as possible.
• Consider elevating the unit in order to keep the hose as straight as possible.
window hose
adapter outlet
Fig. 4
hose
7
hose
inlet
Fig. 17
Fig. 5
NOBOCOOL NC-49DP/C