On-Board Dual Stage Shock Sensor; Shock Adjustment Mode - Avital 3001L Installation Manual

On-board dual stage shock sensor

There is a dual-stage shock sensor inside the control module. Adjustments
are made via programming routine indicated below. Since the shock sen-
sor does not work well when mounted firmly to metal, we recommend
against screwing down the control module. The full trigger of the onboard
shock sensor reports zone 2. See Table of Zones.
When adjusting the sensor, it must be in the same mounting location
after the install is completed. Adjusting the sensor and then relocating
the module requires readjustment.
The system must be disarmed. Doors and other protected entries must be
closed, and the ignition Off.
To enter Shock Adjustment Mode:
N N o o t t e e : : Door locks must be learned prior to entering shock sen-
sor adjustment mode.
Start with the system disarmed, and sit in the driver's seat. Make sure
you have the OEM remote and the ignition key.
Turn the ignition key switch on, then off, three times in three sec-
1.
onds: On, off, on, off, on, off.
The siren/horn sounds three short chirps or honks. The Status LED
2.
will blink to indicate the current setting.
3. The adjustment mode lasts for 20 seconds. If no adjustments are
made, the system exits the adjustment mode 20 seconds later. To
extend the time, press the Valet Switch (see note below).
To increase sensitivity, press the Unlock button on the OEM remote.
4.
To decrease sensitivity, press the Lock button.
© 2009 Directed Electronics
27