Software Installation; System Requirements; Usb Driver Installation; Graphic Editor Installation - Ecleree AMIC24 User Manual

4. SOFTWARE INSTALLATION

4.1. System requirements

.amiclab2 needs a PC with Windows® 98SE/ME/2000/XP/VISTA (a Pentium III 600MHz or more
with 128 MB of RAM or greater is recommended), a USB port (1.1 or 2.0), and a VGA video card with a
minimum 800x600 resolution (1024x768 recommended). The computer doesn't act upon audio
processor efficiency, since all processing is done inside AMIC24 DSP. It is only used to graphically edit
parameters.
Before being able to use .amiclab2 to communicate with AMIC24, you have to install the USB
driver. This driver allows the PC to recognize AMIC24, and gives .amiclab2 a method to communicate
with hardware.

4.2. USB driver installation

In order to install the USB driver, you'll need "amicusb.inf" and "amicusb.sys" files from .amiclab2
CD-ROM:
1. Connect the USB cable between AMIC24 and the computer. A "Found New Hardware Wizard"
window will appear.
2. Select "Install from a list or specific location" and type the previous files path.
The wizard will automatically install the driver.

4.3. Graphic editor installation

1. Run the "setup_amiclab2.exe" file and follow installer instructions.
2. .amiclab2 will be installed in a folder named "Ecler\amiclab2", in the hard disk "Program Files"
folder. During installation, you can choose a different location for the software.
3. Confirm each installation process window by clicking on "Next" button. Installation may be
cancelled at any time by clicking on "Cancel" button.
4. When installation is complete, click "Finish" to go back to Windows® desktop or automatically
launch .amiclab2 if "Launch .amiclab2" option has been chosen.
7