Drivers; Hardware Installation; Installing The Card; Interrupt And Memory Address - Digigram VX222v2 User Manual

D i g

Drivers

The table underneath shows the drivers of the VX kit available for each
supported operating system.
Windows 98 SE & ME
Windows 2000
*
Windows XP
Windows Server 2003
Mac OS X
Note: "MME driver" is sometimes mentioned on software requirement charts. It
refers to as "Wave".
"DirectX driver" is sometimes mentioned on software requirement charts. It
refers to as "DirectSound".

HARDWARE INSTALLATION

The card has to be installed in the computer prior to installing its driver.

Installing the card

Turn off the computer and disconnect its power cord. Open the computer and
position it so that you may easily access its PCI slots. Smoothly insert the card
into a free PCI slot. Press it down to position it firmly. Tighten the screw,
close the computer, connect the power cord and start the computer.

Interrupt and memory address

Hardware interrupt and addresses are automatically set up at start-up by the
PCI PnP BIOS.

SOFTWARE INSTALLATION

Please visit the Digigram web site at www.digigram.com for the most recent
driver.
In case you run a specific application developed or installed by a Digigram
partner, it might require the use of a specific driver version. In this case, make
sure that the updated driver has been approved by your supplier.
Under Windows 9x, the driver is a Wave driver.
Under Windows 2000, XP
In addition, a Wave driver is available, its installation is optional.
Under Mac OS X, the driver is a Core Audio driver
∗
32-bit version
8
i g r
Wave
Yes
Yes
Yes
∗
Yes
No
*
, and Server 2003
a m
DirectSound
No
Yes
Yes
Yes
No
*
, the driver is DirectSound.
ASIO2 Core Audio
Yes No
Yes No
Yes No
Yes No
No Yes