Caring; Installing Batteries; To Install Or Replace Batteries - Cobra microTALK CXT595 Owner's Manual

Cobra cxt595 two-way radio owner's manual
Table of Contents

Advertisement

Introduction
Caring for Your microTALK
Your microTALK
if cared for properly. Handle the radio gently. Keep the radio away from
dust. Never put the radio in water or in a damp place. Avoid exposure to
extreme temperatures.

Installing Batteries

To install or replace batteries:

Remove Belt Clip
HI / LO
Pull Up Lock Latch
Insert Batteries
Radio Charger Jack
Use only the supplied rechargeable batteries and charger for recharging
your Cobra microTALK radio.
Cobra recommends your radio is turned off while being charged.
Non-rechargeable alkaline batteries can also be used in your radio.
Operation
radio will give you years of trouble-free service
®
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Pull up on the battery door latch to remove the
battery compartment cover.
3. Insert the supplied three AA rechargeable
batteries or non-rechargeable alkaline batteries.
Position batteries according to polarity markings.
4. Replace battery compartment cover and
belt clip.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
To charge batteries in radio:
1. Check to see that the batteries have been
inserted properly.
2. Insert the cable into the charge jack located at
the top of the radio.
3. Plug the cable into USB power source.
Customer Assistance Warranty
Radio
®
Nothing Comes Close to a Cobra
1
®

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the microTALK CXT595 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Cxt545

Table of Contents

Save PDF