Caring For Your Microtalk; Installing Batteries - Cobra ACXT1035R FLT Owner's Manual

Introduction
Operation

Caring for Your microTALK

Your microTALK radio will give you years of trouble-free service
®
if cared for properly. Handle the radio gently. Keep the radio away from
dust. Avoid exposure to extreme temperatures.

Installing Batteries

To install or replace batteries:
1. Remove belt clip by releasing belt clip latch and
Remove Belt Clip
sliding clip up.
2. Loosen the two top and bottom screws on the back
of the radio to remove the battery compartment
cover. HINT: the screws should be loose enough
(and sticking up) that you could use them to help
pull off the battery door if needed.
Insert Batteries
3. Insert the supplied three AA rechargeable batteries
or non-rechargeable alkaline batteries. Position
batteries according to polarity markings.
4. Replace battery compartment cover, screw down
the screws and re-attach the belt clip.
5. Tighten the screws using the tip of the belt clip to
Tip of Belt Clip
secure the battery door to the radio. Do not overtighten.
Only use the tip of the belt clip to tighten the screws.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
To charge batteries in radio:
Radio Charger Jack
1. Check to see that the batteries are inserted properly.
2. Insert the cable into the charge jack located at the
top of the radio.
3. Plug the charging cable into a power source.
• Use only the supplied rechargeable batteries and charger for recharging
your Cobra microTALK radio.
• Cobra recommends your radio is turned off while being charged.
• It normally takes about 15 hours to fully charge batteries.
• Non-rechargeable alkaline batteries can also be used in your radio.
This radio floats with included NiMH battery.
It may not float with some other AA batteries.
Customer Assistance Warranty
Radio
®
Nothing Comes Close to a Cobra
•
•
1
®
NOTES