Verifying Service Data Changes; Resetting To Factory Defaults - Sony KDL-26S3000 Service Manual

2-5. VERIFYING SERVICE DATA
CHANGES
1. After completing all adjustments turn the set off with the Remote
Commander and then proceed to the next step.
2. Press the following buttons on the Remote Commander within a
second of each other:
Channel 5
DISPLAY
3. To verify the changes repeat steps 1 through 3 of 2-4. Using the
Remote Commander to View Service Data.
4. To exit service mode, turn the power off by pressing POWER .

2-6. RESETTING TO FACTORY DEFAULTS

Use the following instructions to restore the User Controls and
Channel Memory settings to the preset factory conditions.
1. While holding down the on the Remote Commander, press
the POWER button on the Front Panel of the set.
The set restarts and displays the initial setup screen. This may
take several minutes.
KDL-26S3000/32S3000/40S3000/46S3000
Volume + POWER .
KDL-26S3000/32S3000/40S3000/46S3000
99