Desa TC36NE Series Owner's Operation And Installation Manual page 26

FIREPLACE
INSTALLATION
Continued
6. Install rear brick panel first. Rest bottom
edge of panel on back edge of burner
assembly (see Figure 39).
7. Install left side brick panel by sliding it
between burner assembly and side of
firebox (see Figure 39).
8. Install right brick panel using same
method described in step 6 for left brick
panel.
9. Replace deflector shield using screws
removed in step 4.
10. Using screws removed in step 4, replace
plenum and attach to burner.
11. Using screws removed in step 3, replace
log/grate assembly. Be careful when
replacing log/grate assembly not to chip
logs on burner.
12. Install lava rock and glowing embers. See
Installing Lava Rock and Glowing Embers,
page 25.
13. Close glass door and lock latches on top
and bottom of door and replace screen.
See Removing Glass Door, steps 5 and
6, page 25.
14. Close top and bottom louvers.
Left Side Brick
Panel
Rear Brick Panel
Figure 39 - Installing Rear Brick Panel
26
WALL SWITCH INSTALLATION
Installation of a wall switch allows you to
activate gas control valve and turn fireplace
on and off. Wall switch is to be connected to
incoming 120 volt regular household wiring
that supplies electricity to fireplace.
OpTIONAL REMOTE CONTROL
INSTALLATION (MODEL WRC)
Note: If using optional wireless hand-held
remote control, wall switch must be in the ON
position to be operational. Remote control
then becomes the switching mechanism for
fireplace operation.
1. Open lower louver panel.
2. The WRC model receiver does not require
a battery. Receiver can be installed by
first plugging short extension cord into
fireplace receptacle. Plug receiver unit
into extension cord. Plug ignition module
plug into receiver unit (see Figure 40).
3. Activate remote handset battery by re-
moving insulating tab on back of handset
(see Figure 41). Battery is included, pre-
installed.
4. Once battery is activated unit is ready to
use.
5. Close lower louver panel.
Fireplace
Receptacle
Extension Cord
Figure 40 - Installing the WRC Remote
Figure 41 - Installing Battery into Back of
www.desatech.com
Receiver
Battery Cover
12 Volt Battery
Back of
Handset
Handset
Remote
Control
Receiver
Ignition
Module Plug
Pull to Remove
Insulation Tab
116234-01H