Sven X-PAD AERO Operation Manual page 5

ENG
Battery installation
• Open the cover of the battery box on the rear of
the manipulator.
• Install AAA type batteries into the battery box fol-
lowing their polarity. (included).
• Close the cover of the battery box.
Note:
• Always install a set of the same new bat-
teries. Incorrect installation of batteries may
damage the game controller!
• If the manipulator does not work, check the
battery or replace the discharged battery with
a new one.
• Remove the battery from the manipulator, if
you aren't going to use it for a long time (more
than a week).
7. CONNECTION AND INSTALLATION
• After installation of batteries (Fig. 4 ), connect
2,4GHz Nano receiver via USB cable r to available
USB port of your PC. After connection to your PC,
device is automatically detected as a game
controller and is fully ready for use. However, for
Vibration Feedback function it is necessary to
install drivers. Calibration of second joystick is also
impossible without installation of drivers.
• Change POWER ON/OFF switch m into ON
position. For connection of Gamepad and Nano
receiver press FC button s of Nano receiver, the
connection indicator t will light up, then press FC
button e on the game controller. There is also
another way for connection of Gamepad and Nano
receiver: press FC button FC s of Nano receiver,
then press at the same time combination of
buttons «9+11» on the gamepad and hold these
buttons for 15 seconds. Attention should be paid
that Nano receiver and gamepad will be
disconnected, if a gamer presses one of «9+11»
buttons after connection has been made.
• Insert Software CD disk into your PC CD Rom
and start setup.exe for installation of drivers. For
testing and setting the game controller choose
Start → Control Panel → Game Controller. There will
open up Properties: PC TWIN SHOCK (Fig. 6) on
your desktop.
4
PC Wireless Gamepad
Fig. 6
Fig. 7