Step 4. Mounting The Drive In The Bay; Step 5. Attaching The Cables To The Drive - IBM 22P6959 User Manual

Step 4. Mounting the drive in the bay

Attention: Be sure to use the mounting screws in the option package when
you are driving screws directly into the drive. Using screws that are too long
might damage the drive.
You can mount the CD-RW/DVD-ROM Combination Drive horizontally or
vertically in the computer. If you mount the drive vertically, you must secure
any discs that you place into the drive before the drive tray is closed, or the
CD-RW/DVD-ROM Combination Drive will not be able to read the disc
properly.
1. Slide the drive into the bay. Your computer might have specific required
procedures for installing storage devices. For more information on storage
devices, refer to the documentation that comes with your computer.
2. Align the drive-bay screw holes with the threaded holes in the drive
housing or mounting bracket.
3. Thread the screws in loosely to check their position. Two screws are usually
used on each side. Verify that the alignment is correct; then tighten the
screws to secure the drive. Do not overtighten.

Step 5. Attaching the cables to the drive

The following diagram shows where to connect the cables to the drive.
1-6
IBM 8x4x32x8 CD-RW/DVD-ROM Combination Drive: User's Guide