Tape Cartridge Specifications And Capacities; Regulatory Compliance - IBM 4690 User Manual

Environmental Requirements
Specification
Vibration
Peak to peak
displacement
Peak
acceleration
Acoustic level operational (a-wt
sum)
Shock (1/2 sine wave)
Tape Cartridge Specifications and Capacities
The tape drive uses prewritten cartridges. An 8-mm Travan (740 feet) 4.0 GB
capacity tape is recommended.

Regulatory Compliance

The tape drive complies with the regulations listed in the following table.
Regulatory Compliance
Agency
CSA
TUV & IEC-RHEINLAND
UL
Canadian Department of Communications
VDE
FCC
Use the tape drive only in equipment where the combination has been determined
to be suitable by an appropriate certification organization (for example,
Underwriters Laboratories Inc. of the Canadian Standards Association in North
America). Consider the following safety points:
v Install the drive in an enclosure that limits the user's access to live parts, gives
v Provide the correct voltages (+5 V dc and +12 V dc) based on the regulation
adequate system stability, and provides the necessary grounding for the drive.
applied — Extra Low Voltage (SEC) for UL and CSA and Safety Extra Low
Voltage for BSI and VDE (if applicable).
Operational
0.005 in. max
(5 to 44.3 Hz)
0.50 g max
(44.3 to 500 Hz)
55 dBA maximum (measured
in suitable enclosure at 3-ft.
distance and operator height)
2.5 g peak
11 millisecond
Regulation
C22.2, No. 950-M89
EN 60 950/IEC 950
1950
Class B
Class B
Class B, Part 15
Chapter 4. Tape Drive Specifications
Nonoperational
0.1 in. max
(5 to 17 Hz)
1.5 g max
(17 to 500 Hz)
—
100 g peak
11 millisecond
21