Advertisement
2
On the TS1 press the Pair with Panel button.
The Control Panel displays the message:
Pair with TS1. Initiating learning process.
When learning is complete, both the TS1 and Control Panel display
the message:
The learn operation succeeded.
2a
The Control Panel displays the message:
Type: TS1 Wireless Keypad ID#: X
(where X is the RF Keypad number configured for the TS1).
The TS1 displays "Network ID: xxxx" where xxxx is a unique
2b
hexadecimal number and a keypad ID. The hexadecimal number
is a unique number associated with the Control Panel that you
are using. The keypad ID indicates the keypad that you are
learning into the Control Panel.
2c
To complete the learning process, press the OK button on both
the Control Panel and the TS1.
3
After successfully learning the TS1 into the Control Panel, press the
↓ arrow to exit the learning menu.
The TS1 displays a message indicating that the security system is
temporarily inoperable. The TS1 remains in this state while the
Control Panel is in system configuration (programming) mode.
Repeat the steps above to learn in additional TS1s.
To exit programming, click skip then end and exit. Upon exit, the
4
Control Panel takes a several seconds to reboot.
REMOVING A TS1 FROM A CONTROL PANEL
(UNLEARNING THE TS1)
To remove a TS1 from a Control Panel's configuration do the following:
1
From the Control Panel, go to Installer Toolbox / System
Configuration.
2
Select the Go To button and enter 04. The Control Panel displays
Q4: select RF keypad # (1 to 4). Select the configured TS1 you wish to
remove and press the ↓ arrow.
Mark the RF Keypad number selected as "unused" by pressing the →
3
arrow. This action toggles the setting on the first question between
4
©2013 2GIG Technologies Inc. All Rights Reserved.
"used" and "unused." Press the ↓ arrow to advance to the next
option.
4
To exit programming, click skip then end and exit. Upon exit, the
panel takes several seconds to reboot.
RESETTING A TS1 TO FACTORY DEFAULTS
To reset the TS1 to defaults so that it may be used again on another
Control Panel, do the following:
1
Hold both the
(Emergency) and the
simultaneously until they light up (approximately 20 seconds). When
both buttons light up, the TS1 has successfully been reset to all
default settings.
The TS1 displays the message:
This Device is Not Paired with a Control Panel.
SECRET DURESS BUTTON
TIP:
The logo on the bottom corner of the Home Screen does not
access the Installer Toolbox on the TS1.
If a user presses the logo on the bottom corner of the TS1 Home Screen,
the user can enter the duress code only. Installers must remember that
the Installer Toolbox can only be accessed from the Control Panel. The
TS1 cannot access the Installer Toolbox.
TIP:
Although there is a default master code: 1111, there is no
default duress code.
(Home) buttons down
Advertisement
