i. Tech Dynamic i.VoicePRO Bluetooth Clip Headset User Manual page 2

Getting Started
Before using your i.VoicePRO ("headset") for the first time, please ensure that
1. the headset is fully charged;
2. the fully charged headset must be paired and connected with a Bluetooth mobile
phone.
Charging Your Headset
The headset comes with a built-in rechargeable battery. Prior to using the headset for
the first time, you are recommended to fully charge the battery.
USB Charging Socket
Use only the supplied charger to charge the headset.
Pairing Your Headset with Two Mobile Phones (Multipoint)
i.VoicePRO supports a Multipoint function to allow simultaneous pairing of the
headset with two mobile phones.
1. Follow the pairing procedure as instructed in "Pairing Your Headset with a
Bluetooth
Mobile Phone" to pair the headset with the first mobile phone.
2. Repeat the pairing procedure for the second mobile phone.
3. On the first mobile phone's menu, activate its
headset.
Using Your Headset
Function Button
Power ON Press and hold the MFB for 2
seconds
When you turn on your headset for the first time, the headset automatically enters the
pairing mode, i.e. the status indicator flashes blue and red alternately. This allows you
to immediately pair your headset and mobile phone.
Power OFF Press and hold the MFB for 2
seconds
4
Bluetooth
connection with the
Audio Status Indicator
a short beep Flashing blue light 3
times
a long beep
Red light for two seconds
and then the light goes off
6
Charging Your Headset (cont'd)
Status Status Indicator
• Charging • Red light
• Fully charged • Blue light
• Low battery • Flashing red light
• Out of battery • The light goes off
♦ 3 hours are required to fully charge the headset.
♦ Charging indication will be delayed for a few seconds if the headset has not been used
for a long time or the battery is drained.
Pairing Your Headset with a
Bluetooth
1) Ensure the headset is off.
2) To activate the pairing mode, press and hold the headset's MFB for 8 seconds without
releasing your finger until its status indicator flashes blue and red light alternately.
3) Activate your mobile phone's Bluetooth, search Bluetooth devices, select "i.VoicePRO"
and enter the passcode "0000". If your mobile phone supports Bluetooth v2.1 "Simple
Pairing" function, no passcode is required. When the pairing is completed, the headset's
status indicator will flash blue light rapidly five times.
If the pairing cannot be completed within three minutes after the pairing mode has been
activated, the headset's status indicator will flash purple rapidly five times and then turns
off. Repeat steps 1 to 3 to pair both devices again.
Using Your Headset (cont'd)
Function Button
Answer a call Press the MFB once
End a call Press the MFB once
Adjust Volume Press the Volume Key once to
increase / decrease by 1 step
(Total 6 levels)
Voice Dialing Press the MFB once
Say the voice tag as soon as you hear the short beep and you must have recorded the voice
tag into your mobile phone.
Last No. Redial Double click the MFB
Call Reject Press and hold the Volume Key a short beep
for 2 seconds
Call Transfer While speaking, press and hold
(headset to mobile phone) the Volume Key for 2 seconds
Call Transfer While speaking, press MFB once
(mobile phone to headset)
Audio
• a short beep every 1 minute
Mobile Phone
Audio Status Indicator
Flashing blue light
Flashing blue light
a short beep Flashing blue light
a short beep Flashing blue light
Flashing blue light
Flashing blue light
Flashing blue light
Flashing blue light
5
7