Siemens Gigaset S450 IP User Manual page 9

First Steps
Inserting the batteries
Warning:
Use only the rechargeable batteries recom-
mended by Siemens on page 36! This means
that you must not use conventional (non-
rechargeable) batteries or other battery types,
otherwise serious damage to health and prop-
erty cannot be ruled out, e.g. the outer casing
of the batteries could be destroyed or the bat-
teries could explode. The phone could also
malfunction or be damaged as a result of using
batteries that are not of the recommended
type.
¤
Insert the batteries the right way round
(see figure).
The polarity is indicated in/on the battery
compartment.
The handset turns on automatically.
You will hear a confirmation tone.
Closing the battery cover
¤
First, align the notches on the side of
the battery cover with the protrusions
on the inside of the housing.
¤
Then press the cover until it clicks into
place.
8
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Place your finger in the headset socket
cavity and pull the battery cover
upwards.
Connecting the charging cradle
Connecting up the charging cradle and
mounting it on the wall (if required) is
described at the end of this user guide.
¤
To charge the batteries, leave the hand-
set in the charging cradle.
Please note:
– Only place the handset in the charging cra-
dle that is intended for it.
– If the handset has turned itself off because
the batteries are flat and if it is then placed
in the charging cradle, it will turn itself on
automatically.