Volvo XC70 Owner's Manual page 159

1.5.3 AF
1.5.4 EON
Off
Local
Distant
1.5.5 Regional
1.5.6 Reset all FM settings
Radio system - DAB*
General
DAB (Digital Audio Broadcasting) is a digital
broadcasting system for radio.
NOTE
This system does not support DAB+.
Service and Ensemble
•
Service - Channel, radio channel (only
audio services are supported by the sys-
tem).
•
Ensemble - A collection of radio channels
on the same frequency.
6 Not all areas/countries use both wavelengths.
7 During a build-up phase DAB will not cover the whole country but will only work in larger urban areas.
Storing channel groups (Ensemble learn)
When the vehicle is moved to a new broad-
casting area, programming of existing channel
groups in the area can take place.
Programming of channel groups creates an
updated list of all available channel groups.
The list is not updated automatically. Program-
Ensemble learn
ming takes place via the
menu or directly by means of a long press on
AUTO. If can take up to a minute to program a
channel group if both Band III and
selected.
Wavelength
DAB is transmitted on two wavelengths
III LBand
and .
•
Band III – over the whole country
•
LBand - mainly in large cities
By selecting for example Band III
channel programming takes place more
quickly than if both Band III and
selected. It is not certain that all channel
groups will be found. Wavelength selection
does not affect the stored memories.
Navigation via lists
There are three types of basic list which can be
used for navigation:
04 Comfort and driving pleasure
•
Ensemble
the receiver has obtained via channel
group programming.
•
Service - Shows channels irrespective of
the channel group to which they are allo-
cated. The list can also be filtered using
DAB PTY
•
Subchannel
channel.
The lists can be accessed via the menu. The
LBand are
channel groups can also be accessed by
pressing ENTER.
Scanning
6
; Band Scanning means that all channels in the list are
played for 10 seconds each.
±
7
Press SCAN
Scanning can also be selected in DAB-PTY
mode. In which case only channels of the pre-
on its own,
selected programme type are played.
LBand are ±
Stop scanning by pressing SCAN once, or
by pressing EXIT.
Subchannel
Secondary components are usually named
subchannels. These are temporary and can
contain e.g. translations of the main pro-
gramme into other languages.
*
Option/accessory, for more information, see Introduction.
Audio system
- Shows channel groups that
(see below).
- Subchannels to a selected
to activate
04
``
159