Transporting The Log; Splitter - Greyhound 65075 Set-Up & Operating Manual

5. Move the Directional Valve (58) into
the lower position; moving the Slide
Assembly (3) to split the log.
6. To stop the advance of the Slide As-
sembly at any time, move the Direc-
tional Valve to the middle position.
7. Once the log is split, move the Direc-
tional Valve to its upper position to
back the wedge off the log and re-
move the split pieces.
8. Continue as detailed above until all
logs are split.
9. To prevent accidents, turn off the en-
gine and after the engine has cooled,
disconnect its spark plug wire after
use. Drain all water out of the unit.
Clean external parts with clean cloth,
then store the equipment out of chil-
dren's reach according to the Storage
instructions in this manual.
transporting the log splitter
Warning!
iMportant inForMation
This trailer's Hitch Coupler MUST
be properly secured to the hitch ball of
the towing vehicle. After assembly and
attachment, pull up and down on the Hitch
Coupler to make sure the hitch ball is fitting
snugly in the Hitch Coupler. there must
be no play between the hitch ball and
Hitch coupler. If there is play, tighten the
Adjustment Nut until no play is present. If
the Adjustment Nut is too tight, the Handle
will not lock. carefully read and follow
the complete instructions in this manual
BeFore setup or use.
if the coupler is not secured properly,
the ball could come loose while the trailer
is in motion, possibly causing property
damage, serious personal injury,
or deatH.
SKU 65075 For technical questions, please call 1-800-444-3353.
note: This Log Splitter is not road legal
and should not be conveyed on pub-
lic roads.
• When transporting the Log Splitter,
make sure your hitch (not included)
is compatible with the Hitch Coupler
(9).
• Follow all of the safety warn ings for
towing in the vehicle's manual.
• Use the Safety Chain with Hook (4)
when towing.
• Do not tow the Log Splitter at
speeds above 40 MPH.
• Travel with the Front Leg Assembly
and Rail Assembly in the horizontal
position.
• Cover the air inlet hole on the Plug
during transport.
10. Pull up and down on the Hitch Cou-
pler to make sure the hitch ball is
fitting snugly in the Hitch Coupler.
There should be no play between the
hitch ball and Hitch Coupler. If there
is play, tighten the Adjustment Nut
until no play is present. If the Adjust-
ment Nut is too tight, the Handle will
not lock.
Page 14