Troubleshooting - I-O DATA SRDVD-100U User Manual

Troubleshooting

Problem
The AVeL Link Player does
not power up.
The remote controller does not
work.
No screen is displayed.
The server icon is not
displayed in the AVeL Link
Player menu.
The USB equipment is not
recognized.
The login screen does not
respond.
The message "Cannot connect
to the specified server" or
"Log in to AVeL Link later" is
displayed, and files in the
server (computer) are not
shown.
AVeL Link Server is running,
but the AVeL Link Player
does not respond.
５２
Cause/Point to check
Is the power cable connected to the
power socket?
Is the power cable connected to the
AVeL Link Player?
Aren't the batteries in the remote
controller low?
Are the batteries connected in the
correct polarities (positive, negative)?
Is the remote controller facing the AVeL
Link Player?
Video Output is set to a mode not
matching the connected TV or monitor.
AVeL Link Server has not been started.
The network is not set up correctly.
Isn't the hub or router hindering proper
network connection?
The power to the AVeL Link Player was
turned on with the USB equipment
connected.
The network is not set up correctly.
The hard disk storing the specified
Watch Folder or Library Folder has
been removed.
The specified folder contains too many
files.
Connect the power cable to the power socket.
Confirm that the power cable is connected to the AVeL Link Player.
Replace them with new batteries.
Set the batteries correctly.
Operate the remote controller by orienting it toward the
remote-controller light-receiving part on the AVeL Link Player
(located at the front center of the AVeL Link Player).
[1] Press the TV MODE button on the remote controller several
times until the screen is displayed.
[2] Set Video Output to match the output of the connected TV or
monitor by referring to "Options" (p.71).
Check if the computer is on and AVeL Link Server is running.
For detail check procedures and actions to be taken, refer to "When
the AVeL Link Player Cannot Connect to a Server (Computer)"
(p.55).
Connect the AVeL Link Player to the computer directly using a
cross cable and then check if the problem persists.
(If the AVeL Link Player is connected to the computer directly, the
IP addresses of the AVeL Link Player and computer must be
manually entered.)
Turn on the power to the AVeL Link Player first, and then turn on
the power to the USB equipment.
For detail check procedures and actions to be taken, refer to "When
the AVeL Link Player Cannot Connect to a Server (Computer)"
(p.55).
Install the hard disk again, or do not specify the Watch Folder or
Library Folder in the hard disk you want to remove.
Reduce the number of files and then check if the problem persists.
Action