Positioning - Viking VCSB423 Installation Instructions Manual

Built-in side-by-side refrigerator/freezer
Hide thumbs Also See for VCSB423:
Table of Contents

Advertisement

Before moving the refrigerator in place, confirm the finished dimensions, electrical location, minimum door and shelf
clearances, and door panel instructions. (See pages 3, 4, & 5).
1. Position refrigerator in front of cutout.
2. Verify operation by plugging power cord in receptacle. P P o o w w e e r r s s w w i i t t c c h h w w i i l l l l b b e e s s h h i i p p p p e e d d i i n n t t h h e e " " O O N N " " p p o o s s i i t t i i o o n n a a n n d d
s s h h o o w w r r o o o o m m s s w w i i t t c c h h w w i i l l l l b b e e i i n n t t h h e e " " O O N N " " p p o o s s i i t t i i o o n n . . (If showroom switch is switched to the "OFF" position, showroom
mode is engaged and power is shut-off to the compressor. This mode is for showroom display only).
3. Roll refrigerator into cutout to within 3" (7.6 cm) of being flush with cabinets. To avoid kitchen cabinet damage,
place cardboard between cabinets and refrigerator. Push cardboard back with refrigerator and remove cardboard
when refrigerator is in place. NOTE: When moving the unit into position, be careful not to crimp, kink or crush
the copper water supply line.
4. Lift the refrigerator off the rollers, adjust to desired height and level refrigerator by using a 5/16" hex head wrench.
(Refer to Figure at the right)
a) To raise (clockwise)/lower (counterclockwise) right
side rear, rotate the right side rear hex rod.
b) To raise (clockwise)/lower (counterclockwise) the
left side rear, rotate the left side rear hex rod.
c) To raise (clockwise)/lower (counterclockwise) the
right side front, rotate the right side front hex rod.
d) To raise (clockwise)/lower (counterclockwise) the
left side front, rotate the left side front hex rod.
N N O O T T E E : DO NOT use an electric driving device.
Overtightening can cause damage.
5. Align refrigerator with sides of cabinets by adjusting leveling legs. Rotate leveling legs until firmly in place against
floor.
6. To secure refrigerator, raise unit until compartment cover is firmly seated under the soffit or anti-tip boards.
7. Open door. Display should flash. Press any key. There is a 6 minute delay before the refrigerator starts. Verify the
position of the power on/off and showroom switch if there is no power to refrigerator.
V V I I E E W W S S H H O O W W N N W W I I T T H H K K I I C C K K P P L L A A T T E E R R E E M M O O V V E E D D
29
P P o o w w e e r r
S S w w i i t t c c h h
S S h h o o w w r r o o o o m m
S S w w i i t t c c h h

Advertisement

Table of Contents
loading

Table of Contents