Kickplate Installation; Door Stop Adjustment; Hinge Adjustment - Viking VCSB423 Installation Instructions Manual

KICKPLATE INSTALLATION

Align the holes on both ends of the louvered panel
with the holes in the base of the refrigerator.
Adjust the kickplate to the desired height and fasten
in place by tightening the screws in the slot. Attach
the kickplate to the refrigerator on each side with the
two black phillips head screws provided.

DOOR STOP ADJUSTMENT

1. Using a 3/16" allen wrench, remove door stop pin located in bottom hinge.
2. The pin is factory set 110
pin to the utmost rear stop hole.

HINGE ADJUSTMENT

1. Using a 3/16" allen wrench, remove the door stop pin located in bottom hinge.
2. Using the height adjustment shim as a wrenching device, rotate the height adjustment bushing counterclockwise to
raise or clockwise to lower the location of the door.
3. When proper adjustment is reached, align shim with door stop pin holes and replace door stop pin. Firmly tighten
pin in place.
o . For 120 o swing, move the pin to the utmost forward stop hole. For 90
120 o 90 o
position position
Slots for
adjustments (on
both ends)
Door stop
pin
34
Attach to unit with
screws
(on both ends)
o swing, move the