Advertisement
Quick Links
Menvier40/100/300
Quick User Guide
Full Set
Part Set
Either:
Present your
proximity tag here.
Menvier300
12:20
13/03/2012
�
�
�
�����
�
������
�
�
Press both buttons at
the same time to start
a Hold Up Alarm (your
system may not be
programmed to use
these buttons).
Red when Full Set*
Red when Part Set*
*Your system
may not be pro-
grammed to use
these LEDs.
�����
�����
�����
�����
�����
������
�
�
Or:
Key in your access
code here.
Advertisement
Related Manuals for Cooper Security Menvier40
Summary of Contents for Cooper Security Menvier40
-
Page 1: Full Set
Menvier40/100/300 Quick User Guide Red when Full Set* Red when Part Set* *Your system Menvier300 may not be pro- 12:20 13/03/2012 grammed to use these LEDs. � � ����� ����� Full Set � ����� ����� ����� Part Set � ������... -
Page 2: Unsetting The System
Starting to Set: The siren stops. The display shows the first zone to alarm. 1. Go to the keypad and key in your access Press tick to Reset code. (Alternatively, if you have a proxim- Burg Z04 Alarm ity tag, present your tag to the keypad.) Either - Full Set: 4. - Page 3 Secure all your windows and doors. The bottom line of the display shows a Make sure the system is idle, and that you message describing the most recent ac- can hear the warning tones from the keypad. tive alert. 1. Press the appropriate button on the re- If you press ...
- Page 4 Every effort has been made to ensure that the contents of this book are correct. However, neither the authors nor Cooper Security Limited accept any liability for loss or damage caused or alleged to be caused directly or indi- rectly by this book. The contents of this book are subject to change without notice.