Advertisement
Power Switch
Off/Standby/On
This switches the amplifier from OFF to STANDBY mode, where only the valve filament
heaters are on, to ON for actual use. This should be used correctly every time the unit is
used to prevent problems with valves and to increase their life. Please refer to SWITCH
ON SEQUENCE earlier in the manual.
After switching of it is recommended, as with all valve amplifiers, that it does not receive
any sudden physical shocks while the valves are still hot, i.e. through moving the unit. If
possible try to give the amplifier a few minutes to cool down before transporting it.
REAR PANEL
GA-30RV & GA30RVH
GA-60RV
Footswitch Control Sockets
DIN Socket - For 5-Way Foot Controller
This is an 8 pin DIN connector that when connected to the optional five way foot
controller allows the user to do the following:- switch between PREAMP 1 and PREAMP
2, switch BOOST on and off, switch both preamps
on, switch EFFECTS LOOP on and off and REVERB
on and off.This socket may also be used to connect
the SUPER "GOLDTONE" to an external (MIDI)
switching unit, with an appropriate lead dependant
on particular device used.
Bear in mind that the SUPER "GOLDTONE"
internal switching is designed to respond to
momentary (non latching) switching and that
the external switching unit should be set for this.
For more advice on this please contact the
Service Dept. or distributor in your territory.
PIN CONNECTION FOR
8 WAY DIN CONNECTOR
7
Advertisement
