Linking Your Scanner To The View App; Allowing Location Services; Syncing Data - MonaVie VIEW User Manual

linking Your scanner to the VIeW app

Once the scanner and MonaVie VIEW app have been
successfully paired using Bluetooth, you must link the scanner
to the MonaVie VIEW app before you can begin scanning.
To do this, open the MonaVie VIEW app:
a) Open or launch the MonaVie VIEW application.
b) Select the OK button when you are prompted with the
message dialog "The VIEW. Would you like to use your
current location? OK or Don't Allow."
c) Enter your MonaVie Distributor ID and MonaVie
Password.
d) Click Continue.
22
The app authenticates your distributor id and password
against your assigned scanner and, if successful, will
display all your available options.

Allowing Location Services

The app requires you to enable location services. This
allows the software to provide accurate information, units
of measurements, and other security features based on the
location where you are scanning. Location Services also
ensure that the scanner is being used in compliance with
international rules and regulations. On the MonaVie VIEW
Antioxidant Scanner website, you can see a map showing
all the MonaVie scans currently taking place by clicking on
the GPS Map tab at the top of the page.

Syncing Data

With your scanner and mobile device properly paired and
linked, the scanning data will automatically sync between
the unit and mobile device as long as both are turned on
and within proximity of each other.
*Images in this guide represent general functions of the VIEW
software app. Screen shots may vary depending on your device.
EN US/CA Version 1.1