Suggested Tool Requirements; Preparation Of Chassis; Cabinet Installation - LG R-8000A Service Manual

SUGGESTED TOOL REQUIREMENTS

SCREWDRIVER(+, -), RULER, KNIFE, HAMMER, PENCIL, LEVEL

PREPARATION OF CHASSIS

1. Remove the screws which fasten the cabinet at both
sides and at the back.
2. Slide the unit from the cabinet by gripping the base
pan handle and pulling forward while bracing the
cabinet.
3. Cut the window sash seal to the proper length.
Peel off the backing and attach the foam-pe ¨ó to the
underside of the window sash.
4. Remove the backing from the top upper guide Foam
PE ¨ð and attach it to the bottom of the upper guide
¨ï .
5. Attach the upper guide onto the top of the cabinet with
3 type A screws.
6. Insert the frame guides ¨ñ into the bottom of the
cabinet.
7. Insert the Frame Curtain ¨ç into the upper guide ¨ï
and frame guides ¨ñ .
8. Fasten the curtains to the unit with 4 Type A screws.

CABINET INSTALLATION

1. Open the window. Mark a line on center of the
window stool(or desired air conditioner location).
Carefully place the cabinet on the window stool and
align the center mark on the bottom front with the
center line marked in the window stool.
2. Pull the bottom window sash down behind the upper
guide until it meets.
NOTE:
• Do not pull the window sash down so tightly that the
movement of Frame Curtain is restricted.
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
13
9
(Type A)
5
5
Upper Guide
Window Sash
Foam-pe
13
Cabinet
Frame Curtain
Foam-pe
- 14 -
Shipping
Screws
5
(Type A)
11
Window stool
Front Angle Figure 20
Upper guide
9
1
10
Figure 21
LGE Internal Use Only
11