Operation And Adjustments; Assembly And Removal Of Back Support; Changing Harness Strap Adjustment - Baby Trend HYbrid 3-in-1 Owner's Manual

Operation and Adjustments

10.0

10.1 Assembly and Removal of Back Support

Before using your Car Seat in your vehicle, you must assemble the
Back Support and prepare the Car Seat harness straps for your child.
To assemble Back Support:
• Place Car Seat on the floor or other
firm surface and loosen the harness
so Back Support can lay flat behind
the seat base (see "Adjustment of the
Harness Straps" section 10 .2).
• Align both tabs on bottom of Back
Support with openings in back of the
seat base .
1
• Rotate Back Support forward to an
upright position pressing down
2
firmly on top of Back Support until both
tabs are fully inserted into the openings and
the Back Support feels secure and stable
• Check to be sure no parts of the harness
straps or seat pad are trapped between
the Back Support and the seat base
To remove Back Support:
• Place Car Seat on the floor or other
firm surface.
• While holding the Car Seat base down,
pull Back Support straight up until it stops,
then rotate backrest backward and lift out.
NOTE: Follow steps shown in illustrations
but in reverse order.
1
2
.
3
3
.
4
4
75
Operation and Adjustments
10.0

10.2 Changing Harness Strap Adjustment

WARNING!
• To prevent injury from contact with the vehicle interior or
ejection, the harness system must be snugly adjusted
around child.
The harness system on this Car Seat has an adjuster allowing
adjustment of harness strap for a snug fit on your child.
To tighten harness strap:
1. Tighten the harness straps to snugly
adjust harness around child by pulling the
Harness Adjuster Strap at the front of the
Car Seat as shown.
2. Make sure the straps are flat and snug
against the child's shoulders and thighs.
NOTE: A snug strap should not allow any
slack. It lies in a relatively straight line
without sagging. It does not press on the
child's flesh or push the child's body into
an unnatural position.
76