Table of Contents
Advertisement
g. When "End track" is displayed on the LCD, press GO switch to quit directly since first song
number is 4.
h. Press MODE to number 6 at "Begin track" and quit.
i. Press MODE to number 8 at "End track" and quit.
j. Press GO switch directly to following "Begin track" and End track" selection to finish track
selection on master # 1.
k. Duplicator will start to collect the tracks you selected into current partition of hard drive.
l. After loading is finished, duplicator will eject your master disc and show "Pass" on LCD.
m. Place Master # 2 into input hopper and continue the selection from second master disc.
n. Repeat procedures (d) to (j) above.
o. Once the accumulated length of tracks selected has exceeded the maximum capacity in partition,
the duplicator will stop to accept additional tracks.
p. Switch to "Delete" function to delete the last track stored in current partition in hard drive if
necessary.
q. Load blank media in the input hopper and switch to Copy to start copying the new collection.
Example 2: Collect from two masters as follows:
Master # 1:
All tracks (songs)
Master # 2:
track (song) #4 – track (song) #6
a. Load master #1 normally by using Load function. Data, if any, in the current partition will be
erased and replaced automatically by all the tracks in this master disc.
b. Load master # 2 by using EDIT function but keep the data stored in hard drive. There's no need
to do Clear function as described in Example 1 because you will lose the data collected from
master # 1.
c. Repeat the other steps described in Example 1.
3. Delete
When the last music track stored in hard drive is not the one you wish to keep, switch to "delete"
function and press GO to delete it. You may always use this function to delete the last track stored in
the current partition of hard drive.
4. Clear
This function clears the master data stored in the current partition of hard drive. When you want to
EDIT a new collection of songs, you must run this function first to clear the current partition of hard
drive. Perform this function by pressing GO switch at "Clear" function and LCD will show: "Master
cleared".
5. Disc Info
HERA Series CD/DVD Duplication System / User Manual
20
Advertisement
Table of Contents
