Suggested Tool Requirements; Preparation Of Chassis - LG R1402 Service Manual

3.5 SUGGESTED TOOL REQUIREMENTS

SCREWDRIVER(+, -), RULER, KNIFE, HAMMER, PENCIL, LEVEL

3.5.1 PREPARATION OF CHASSIS

1. Remove the screws which fasten the cabinet at both sides
and at the back.
2. Slide the unit out from the cabinet by gripping the base pan
handle and pulling forward while bracing the cabinet.
3. Cut the window sash seal to the proper length. Peel off the
backing and attach the Foam-PE to the underside of the
window sash.
4. Remove the backing from Foam-PE with 3 holes and attach
it to the bottom of the Top retainer bar.
5. Attach the Top retainer bar onto the top of the cabinet with 3
screws (Type A).
6. Insert the Frame guides into the bottom of the cabinet.
7. Insert the Frame Curtain into the Top retainer bar and
Frame guides.
8. Fasten the curtains to the unit with 10 screws (Type A) at
both sides.
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Figure 20
Figure 21
Foam-PE
Figure 22
Top retainer bar
Screw
(Type A)
Figure 23
- 17 -
Shipping screws
Top retainer bar
Foam-PE
Screw(Type A)
Frame guide
LGE Internal Use Only