Terratek PTS10U User Manual page 15

e.g. Cords marked 14 gauge can carry a higher current than cords marked 16 gauge
therefore when linking extension cords make sure each cords wire gauge matches.
Note: Outdoor extension cords used in must carry the letters "W-A" (USA) or "W"
(Canada)
Check all extension cords for damage before use.
Avoid sharp objects.
Do not position the cord where it could be subject to traffic passing over it.
Carefully remove the product and any accessories from the box. Make sure that all
items listed in the packing list are included.
Assembly
Leg Stand Assembly
NOTE: Parts of leg stand (Fig.7) have the locating holes for mounting the dust bag
adaptor plate and the saw bench, these holes must be positioned to the top of the leg
stand. During assemble ensure all locking washers are used in the correct position and
that all connecting nuts and bolts are securely tightened.
Mounting the saw bench
1. Lay the saw bench top down.
2. Locate the dust collector bag adaptor plate (Pt.116),
3. Add the completely assembled leg stand securing both the leg stand and adaptor
plate to the machine body with the enclosed nuts bolts and locking washers.
4. Once assembled turn the complete machine over so that it now stands on the legs,
this requires two people to avoid injury when lifting.
5. Secure the dust bag (Pt.127) to the dust bag adaptor plate (Pt 116) (Fig.8)
Warning !!
Before Assembly DO NOT CONNECT TO POWER SUPPLY.
Saw Bench Assembly
When assembling your machine do not connect to the power supply until you have
fully read and understood this manual. After carrying out all checks and making any
necessary adjustments check that the machine switch is in the off position, connect
to the power supply and then switch the machine on and off quickly, this will allow you
to check for any loose blades or accessories without the machine gaining full speed.
Disconnect from the power supply before attempting any adjustments.
During manufacturing your machine is set and calibrated to cut accurately however
movement can occur during transit. If you find that your machine is not cutting accur-
ately you can make several small adjustments easily.
10