Draft Slide Gate Corrector Install And Adjustment - Magnum 6500 Owner's Manual

ENERGY SYSTEMS, INC.-
AMERICAN
Fax 320-587-8872 or call (800) 495-3196 Technical Support Call (320) 234-0743
ORDER #
AFP24 Spring Handle, Gold, Heat Exchanger Rod
Ash Pan Assembly, MagnuM 7500
CF02
CF06 Firepot, Stainless Steel, Corn/Biomass, 7500
Door, Black, 6500 & 7500, Countryside (when purchased separate from unit)
CF13
Filter, Cold Air Return, MagnuM 6500 & 7500
CF22
CF23 Fan Limit Control, MagnuM 7500 furnace 2004 or earlier, 2E232 (control only, wiring harness sold separate)
Blower/Fan, Room, Complete Assembly (when purchased separate from unit)
CF25
CF26 Motor, Auger Feed Gear, 8 rpm (MagnuM 7500 only)
CF27 Combustion Enhancement System
Motor, Furnace Blower, ¼ hp single speed (3M393) 2004 and older MagnuM 7500 (formerly part CF24)
CF33
CF35 Mount, Motor, New Auger Motor, Retro-Fit Kit (7500 furnace 2003 or earlier) not for new units
Scraper Assembly, Firepot, 6500
CF37
CF38 Firepot, Steel Corn/Biomass, 6500
CF40 Ash Pan Assembly, MagnuM 6500
Door, 24K Gold, 6500, & 7500, Countryside (when purchased separate from unit)
CF3515
CF3519 Door, Nickel, 6500 & 7500, Countryside (when purchased separate from unit)
Draft/Exhaust, 2-speed Output Blowers, MagnuM 6500
MF3650
MF3511 Bushing, Bronze (fuel stirrer shaft bearing) 2 pcs. (7500 & all countryside models)
MF3513S Fuel Stirrer, Welded, Stainless Steel, 7500
Drive Shaft Assembly, Fuel Stirrer, 7500 (includes P003088 ½" ID collar)
MF3514
MF3516 Chain, Fuel Stirrer, 7500
Sprocket, Fuel Stirrer, 11-tooth sprocket on motor, 3/8" Diameter shaft, 7500
MF3517
Sprocket, Fuel Stirrer, 11-tooth sprocket on shaft, ½" Diameter shaft, 7500)
MF3518
MF3521 Scraper Assembly, Firepot, 7500 (all product models except 6500)
Door Handle Assembly 7500, 6500, all Countryside models
MF3523
MF3526 Shoulder Bolt, with nut, ¼-20, Door Latch
Hinge, Door (each) takes two (2) per unit
MF3527
Auger, 1 ½" Corn/ Wood Pellet/ Biomass, 7500 (3500P, 3500L, 3502 models)
MF3530
MF3531 Glass, Door (all models of Countryside & 7500, 6500 Corn Furnace)
Cord, Power, 7500 & 6500 furnace
MF3532F
MF3537 Safety Sensor, Low limit/Fan, 110 deg. (located on Exhaust Manifold & upper air shell, left side)
MF3540 Motor, Fuel Stirrer, MagnuM 7500 & all MagnuM Countryside models
Motor, Auger Feed Gear, 4+ rpm (MagnuM 6500) Also used on MagnuM Countryside models
MF3573
MF3592 Thermostat, Millivolt
Control Board, MagnuM 7500 (current board used on Countryside)
MF3593
MF3594 Control Board, MagnuM 6500
MF3610 Gasket, Exhaust Draft Motor (all models)
Auger, 2" Corn/Wood Pellet / Biomass, 6500
P6006
P7541 Rod, Heat Exchanger, MagnuM 7500
Brick board, 6500 & 7500B
P7554
P003015 Slides, Clean Out, left or right front, MagnuM 7500
Screw, Hex, #8 x ½" Tek ¼"
P003053
Screw, Phillips, #10-32 x 3/8"
P003054
P003073 Door, Clean-out, left or right lower back corners on MagnuM 7500 Furnace
R-116NKL Spring Handle, Nickel, Heat Exchanger Rod (when using Nickel plated door)
Plug, Clean-out, 1 1/2" diameter knockout plug
R0117
RP2050 Thermostat, Hi-Temp, Manual Reset, 225 Deg. 7500 & 6500
Order placement: e-mail: dealersales@magnumheat.com
DESCRIPTION
42