Assembly And Use For The Bowl - Ninja Pulse BL202NZ Owner's Manual

Assembly and Use for the Bowl

ASSEMBLY
Shaft
Or
Fig. 1 Fig. 2
It's best to add the liquid ingredients first and then the dry ingredients.
IMPORTANT: Make sure that the motor
base is plugged in for use.
1 Place the motor base on a clean, dry,
level surface such as a counter or table
top.
2 Align and lower the bowl onto the motor
base. (Fig. 1) Handle should be aligned
slightly to the left of the "LOCK" symbol
on the motor base.
3 Rotate the container to the left as far as
it will go to lock in place. (Fig. 1)
4 Holding the desired attachment by the
shaft, place it onto the drive gear inside
the container. Ensure that the attachment
is seated properly and is standing
upright. (Fig. 2)
NOTE: The blade will fit loosely on the
drive gear.
5 Add the ingredients to the bowl, making
sure that they do not exceed the highest
measured marking line on the side of the
bowl.
6 Holding the lid by the handle in the
upright position, place it on top of the
bowl aligning the arrow ( ) located on
9
BL202NZ_30_IB_ENG_120626_3.indd 9
PULSE
Fig. 3
Fig. 4
7 Push down on the "PULSE" on the handle
8 When you have reached your desired
9 To remove the lid, pull the lid handle
10 Make sure that the unit is unplugged
REMOVAL
Fig. 5
the lid with the arrow ( ) located on the
bowl's handle. (Fig. 3)
to start the appliance. (Fig. 4)
NOTE: Pulse ingredients for even
chopping by pressing down in short
intervals.
IMPORTANT: When using the dough
blade or cookie paddle hold the
appliance to secure the appliance to the
counter or table top.
consistency, stop pressing the lid handle
and wait for the attachment to stop
turning.
up to a 90° angle. Turn the bowl anti
clockwise to lift off the base.
(Fig. 5, Fig. 6)
CAUTION: Never insert your hands in the
pitcher as the blades are sharp. Always
use a spatula to dislodge food that has
stuck to the sides of the pitcher.
when not in use.
Fig. 6
12-06-26 12:57 PM